The lint you can see is not the problem.
Emptying the trap after every load is right, and it is also not enough. The duct behind the machine collects what the screen misses, and that is where fires start.
Google rating from 131 reviews, as of November 17, 2026
Licensed technicians
Quick answer
Dryer vent cleaning clears the lint that collects in the exhaust duct between the machine and the outside wall. The Office of the Fire Marshal names lack of dryer maintenance as a leading cause of dryer fires in the home. Therefore the trap and the duct are two separate jobs, and only one of them gets done after every load.
Key takeaways
- Firstly, clean the lint screen after every single load.
- Rigid or flexible metal duct only, never plastic or foil.
- The straightest, shortest route outdoors collects the least lint.
- Longer drying times are usually the first warning sign.
- Above all, never exhaust a dryer indoors.
Why the duct matters more than the screen
First, the division of labour. The lint screen catches most of what comes off the clothes, but not all of it.
The Office of the Fire Marshal starts with the screen: “Inspect and clean the lint screen after each load of laundry.”
However, the fine lint that passes the screen keeps going. It settles along the duct, especially where the air slows at a bend.
Consequently the duct narrows over years rather than weeks. Nobody sees it happening, because the duct sits behind the machine.
The same guidance therefore adds a second task: “Regularly remove lint from ducts and exhaust vents.”

Which ducting is safe
Secondly, the material. This single choice decides how fast lint builds.
Toronto Fire Services is specific: “Use rigid or flexible metal ducting for venting to the outdoors.”
Then it explains the reason. “Plastic or metal foil ducts are more prone to kinking, sagging and crushing, which leads to lint build-up.”
That failure mode is easy to picture. A crushed foil duct behind a pushed-back dryer becomes a lint trap on purpose.
Route matters just as much. The same service advises homeowners to “Determine the straightest and most direct venting path to the outdoors.”
In practice, every elbow is a place for lint to land. So fewer bends means less cleaning and better airflow.
| Choice | Why it matters |
|---|---|
| Rigid or flexible metal duct | Resists kinking and crushing |
| Plastic or foil duct | Sags and crushes, collects lint |
| Short, direct route | Fewer places for lint to settle |
| Exhaust outdoors only | Indoor venting is unsafe |
| Unobstructed outdoor hood | Flap must open freely |
Signs you have left it too long
Thirdly, the symptoms. They build gradually, which is exactly why they get normalised.
In practice, longer drying times come first. A load that used to take forty minutes starts taking two cycles.
Then the machine runs hot. Clothes come out unusually warm, and the laundry room itself feels humid.
Meanwhile the outdoor hood tells its own story. The Fire Marshal advises you to “Regularly inspect the outdoor vent to ensure it is unobstructed.”
A flap that no longer opens fully, or lint visible around the hood, means the duct is loaded. Besides, birds and small animals nest in hoods that stay shut.
Finally, a burning smell during a cycle is a stop signal. Turn the machine off and leave it off.
What dryer vent cleaning involves
Next, the work itself. It is more than pushing a brush in from one end.
Firstly, the machine gets pulled out and disconnected. That exposes the transition duct, which is usually the dirtiest section.
Then the whole run is brushed through along its length. A rushed dryer vent cleaning skips that part, so ask what the job covers.
After that the outdoor hood gets cleared and checked. A flap that sticks defeats the rest of the work.
Finally, airflow is confirmed at the outlet. In other words, the job finishes with evidence rather than assumption.
Our wider vent and duct services cover this alongside the heating system. Similarly, our notes on duct cleaning explain how furnace ductwork differs.

The rules worth following
However, some of this is about habits rather than hardware. Fire services list them plainly.
Toronto Fire Services names several things not to do. Do not “Overload the dryer,” and never “Exhaust the dryer indoors.”
Besides the machine itself, fabric matters. The same list warns against drying anything “saturated by chemicals, oils or gasoline,” along with foam padded items and rubber backed materials.
The Fire Marshal adds a timing rule that surprises people: “Turn the dryer off if you leave home or when you go to bed.”
Installation is the last of them. Its advice is to “Have your dryer installed and serviced by a qualified technician.”
Above all, working alarms matter. The Fire Marshal recommends smoke and carbon monoxide alarms “on every storey of your home,” tested every month.
Gas dryers deserve an extra note
Meanwhile, a gas dryer is also a fuel appliance. Therefore its venting carries a second consideration beyond lint.
A blocked exhaust on a gas dryer affects combustion products, not just moisture. Consequently the stakes of a clogged duct are higher.
In Ontario, work on fuel appliances belongs to registered contractors. That is a legal boundary rather than a preference.
If you ever smell gas near the machine, treat it as an emergency. Our guide on what to do if you smell gas sets out the order to follow.
Carbon monoxide has no smell, so alarms do the work your senses cannot.
What dryer vent cleaning means around Painswick
Painswick sits in Barrie’s south end, and much of it is family housing with laundry on an upper floor rather than in a basement.
Upper floor laundry usually means a longer duct run. In practice that run travels through a joist space with several bends before it reaches an outside wall.
Consequently lint has more places to settle, and the duct is harder to inspect. A short basement run through the rim joist is a far simpler case.
Winter adds the outdoor half of the problem. Snow banked against a low hood, or ice on the flap, blocks the outlet exactly when the dryer runs most.
Our guide to a furnace vent blocked by snow covers the same hazard on the heating side. We serve Barrie and the rest of Simcoe County.
The dryer is not the only duct that has to end outside. Our guide to the bathroom exhaust fan covers run time and why venting into the attic causes damage.
Talk to Aire One Barrie
We clean the whole run rather than the first reachable metre, and we check the outdoor hood before we leave. We serve Barrie and the rest of Simcoe County from our Burton Avenue shop.
- 24/7 emergency service, including weekends and holidays
- Full length brushing and extraction, both ends checked
- Long upper floor runs and awkward joist routes
- Bonded, factory trained and licensed technicians
Frequently asked questions
How often should dryer vent cleaning be done?
The Office of the Fire Marshal says to clean the lint screen after every load and to regularly remove lint from ducts and exhaust vents, without naming an interval. A long upper floor run with several bends needs attention sooner than a short basement run.
What ducting should a dryer use?
Toronto Fire Services advises rigid or flexible metal ducting for venting outdoors. It warns that plastic or metal foil ducts are more prone to kinking, sagging and crushing, which leads to lint build-up.
How do I know the vent is blocked?
Longer drying times are usually the first clue, often with unusually hot clothes and a humid laundry room. Outside, a hood flap that will not open fully or visible lint around it points the same way.
Can I vent a dryer into the house in winter?
No. Toronto Fire Services lists exhausting the dryer indoors among the things not to do. It puts heat, moisture and lint into the living space, and on a gas dryer it also puts combustion products there.
Is a gas dryer different?
The lint problem is the same, but a gas dryer is also a fuel appliance, so a blocked exhaust affects combustion products as well as moisture. In Ontario, work on fuel appliances belongs to registered contractors.
Aire One has served Ontario since 1990, with Carrier Factory Authorized Dealer status and licensed technicians across Simcoe County.
705-733-1003 · 176 Burton Ave, Barrie, ON
Sources
- Toronto Fire Services, Clothes dryers fire safety — rigid or flexible metal ducting, the kinking and crushing problem with plastic and foil, choosing the straightest venting path, removing lint from metal ducts and exhaust vents, and the list of things not to do including overloading and exhausting indoors.
- Office of the Fire Marshal and Emergency Management, Clothes Dryer safety handout — lack of dryer maintenance as a leading cause of dryer fires, cleaning the lint screen after each load, regularly removing lint from ducts and vents, inspecting the outdoor vent, turning the dryer off when leaving home or going to bed, qualified installation and service, and alarms on every storey tested monthly.










